Effect of Initial Iron Content in a Zinc Bath on the Dissolution Rate of Iron During a Hot Dip Galvanizing Process
- Authors
- Lee, Sang Myung; Lee, Suk Kyu; Paik, Doo-Jin; Park, Joo Hyun
- Issue Date
- Apr-2017
- Publisher
- ASM International
- Keywords
- Mass Transfer Coefficient; Diffusion Boundary Layer; Iron Dissolution; Inhibition Layer; Zinc Bath; LIQUID ZINC; AL; ALUMINUM; BEHAVIOR; SYSTEM; STEEL
- Citation
- Metallurgical and Materials Transactions A: Physical Metallurgy and Materials Science, v.48A, no.4, pp.1788 - 1796
- Indexed
- SCIE
SCOPUS
- Journal Title
- Metallurgical and Materials Transactions A: Physical Metallurgy and Materials Science
- Volume
- 48A
- Number
- 4
- Start Page
- 1788
- End Page
- 1796
- URI
- https://scholarworks.bwise.kr/erica/handle/2021.sw.erica/10047
- DOI
- 10.1007/s11661-017-3966-4
- ISSN
- 1073-5623
- Abstract
- The mechanism of iron dissolution and the effect of initial Fe content in a Zn bath on the dissolution rate of iron were investigated using a finger rotating method (FRM). When the initial iron content, [Fe]A degrees, in the zinc bath was less than the solubility limit, the iron content in the zinc bath showed a rapid increase, whereas a moderate increase was observed when [Fe]A degrees was close to the solubility limit. Based on Eisenberg's kinetic model, the mass transfer coefficient of iron in the present experimental condition was calculated to be k (M) = 1.2 x 10(-5) m/s, which was similar to the results derived by Giorgi et al. under industrial practice conditions. A dissolution of iron occurred even when the initial iron content in the zinc bath was greater than the solubility limit, which was explained by the interfacial thermodynamics in conjunction with the morphology of the surface coating layer. By analyzing the diffraction patterns using TEM, the outermost dendritic-structured coating layer was confirmed as FeZn13 (zeta). In order to satisfy the local equilibrium based on the Gibbs-Thomson equation, iron in the dendrite-structured phase spontaneously dissolved into the zinc bath, resulting in the enrichment of iron in front of the dendrite tip. Through the diffusion boundary layer in front of the dendritic-structured layer, dissolved Fe atoms diffused out and reacted with Zn and small amounts of Al, resulting in the formation of dross particles such as FeZn10Al (x) (delta). It was experimentally confirmed that the smaller the difference between the initial iron content in the zinc bath and the iron solubility limit at a given temperature, the lower the number of formed dross particles.
- Files in This Item
-
Go to Link
- Appears in
Collections - COLLEGE OF ENGINEERING SCIENCES > DEPARTMENT OF MATERIALS SCIENCE AND CHEMICAL ENGINEERING > 1. Journal Articles
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.