Effect of Cooling Flow on the Operation of a Hot Rotor-Gas Foil Bearing System
- Authors
- Ryu, Keun; San Andres, Luis
- Issue Date
- Oct-2012
- Publisher
- American Society of Mechanical Engineers
- Keywords
- Management procedures; Test data; Rigid rotors; Frequency contents; High temperature; Outer surface; Modal damping ratios; Air cooling; Bearing temperature; Comprehensive measurement; Rotor motion; Bearing systems; Cooling; Flow rate; External flow; Cooli
- Citation
- Journal of Engineering for Gas Turbines and Power, v.134, no.10, pp.1 - 12
- Indexed
- SCIE
SCOPUS
- Journal Title
- Journal of Engineering for Gas Turbines and Power
- Volume
- 134
- Number
- 10
- Start Page
- 1
- End Page
- 12
- URI
- https://scholarworks.bwise.kr/erica/handle/2021.sw.erica/31813
- DOI
- 10.1115/1.4007067
- ISSN
- 0742-4795
- Abstract
- Gas foil bearings (GFBs) operating at high temperature rely on thermal management procedures that supply needed cooling flow streams to keep the bearing and rotor from overheating. Poor thermal management not only makes systems inefficient and costly to operate but could also cause bearing seizure and premature system destruction. This paper presents comprehensive measurements of bearing temperatures and shaft dynamics conducted on a hollow rotor supported on two first generation GFBs. The hollow rotor (1.36 kg, 36.51mm OD and 17.9mm ID) is heated from inside to reach an outer surface temperature of 120 degrees C. Experiments are conducted with rotor speeds to 30 krpm and with forced streams of air cooling the bearings and rotor. Air pressurization in an enclosure at the rotor mid span forces cooling air through the test GFBs. The cooling effect of the forced external flows is most distinct when the rotor is hottest and operating at the highest speed. The temperature drop per unit cooling flow rate significantly decreases as the cooling flow rate increases. Further measurements at thermal steady state conditions and at constant rotor speeds show that the cooling flows do not affect the amplitude and frequency contents of the rotor motions. Other tests while the rotor decelerates from 30 krpm to rest show that the test system (rigid-mode) critical speeds and modal damping ratio remain nearly invariant for operation with increasing rotor temperatures and with increasing cooling flow rates. Computational model predictions reproduce the test data with accuracy. The work adds to the body of knowledge on GFB performance and operation and provides empirically derived guidance for successful rotor-GFB system integration. [DOI: 10.1115/1.4007067]
- Files in This Item
-
Go to Link
- Appears in
Collections - COLLEGE OF ENGINEERING SCIENCES > DEPARTMENT OF MECHANICAL ENGINEERING > 1. Journal Articles
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.