Robust shaft design against shaft deformation in hub press-fitting and disk clamping processes of a 2.5 HDD
- Authors
- Kim, Bumcho; Lee, Minho; Jang, Gun hee
- Issue Date
- Jun-2016
- Publisher
- SPRINGER HEIDELBERG
- Citation
- MICROSYSTEM TECHNOLOGIES-MICRO-AND NANOSYSTEMS-INFORMATION STORAGE AND PROCESSING SYSTEMS, v.22, no.6, pp.1299 - 1305
- Indexed
- SCIE
SCOPUS
- Journal Title
- MICROSYSTEM TECHNOLOGIES-MICRO-AND NANOSYSTEMS-INFORMATION STORAGE AND PROCESSING SYSTEMS
- Volume
- 22
- Number
- 6
- Start Page
- 1299
- End Page
- 1305
- URI
- https://scholarworks.bwise.kr/hanyang/handle/2021.sw.hanyang/154424
- DOI
- 10.1007/s00542-016-2850-2
- ISSN
- 0946-7076
- Abstract
- We investigated deformation of the outer diameter of a shaft due to the hub press-fitting and disk clamping processes associated with a 2.5aEuro(3) hard disk drive. We propose a new robust shaft design to minimize the effect of deformation on the outer diameter of the shaft. We numerically show the effect of deformation on the shaft due to the pressure, stiffness, and damping coefficients of fluid dynamic bearings (FDBs), and the critical mass and excitation response of the rotor-bearing system. We also experimentally measured the axial non-repeatable runout and the amplitude at the half speed whirl frequency of FDBs with both conventional and proposed designs. Through these tests we confirm that the proposed design improves the static and dynamic performance of the FDBs and rotor-bearing system.
- Files in This Item
-
Go to Link
- Appears in
Collections - 서울 공과대학 > 서울 기계공학부 > 1. Journal Articles
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.