Characterization of non-amine-based post-copper chemical mechanical planarization cleaning solution
- Authors
- Manivannan, Ramachandran; Cho, Byoung-Jun; Xiong Hailin; Ramanathan, Srinivasan; Park, Jin-Goo
- Issue Date
- Jun-2014
- Publisher
- Elsevier BV
- Keywords
- Post-Cu-CMP; Cesium hydroxide; Ethylene glycol; Non-amine cleaning solution; Benzotriazole
- Citation
- Microelectronic Engineering, v.122, pp.33 - 39
- Indexed
- SCIE
SCOPUS
- Journal Title
- Microelectronic Engineering
- Volume
- 122
- Start Page
- 33
- End Page
- 39
- URI
- https://scholarworks.bwise.kr/erica/handle/2021.sw.erica/22455
- DOI
- 10.1016/j.mee.2014.02.034
- ISSN
- 0167-9317
- Abstract
- Copper surfaces can become contaminated by slurry particles and organic residues during chemical mechanical planarization (CMP). Silica particles are widely used as abrasives, while benzotriazole (BTA) is widely used as corrosion inhibitor, in copper CMP slurries. The contaminated copper surface needs to be cleaned by using an effective cleaning solution. These material contaminate the copper surface during CMP and need to be removed by using an effective cleaning solution. The objectives of this work were to develop a non-amine-based alkaline cleaning solution and characterize the solution based on the benzotriazole (organic residue) removal and particle removal efficiency. Cesium hydroxide and potassium hydroxide were used as cleaning agents and ethylene glycol was used as a corrosion inhibitor. Ethylene glycol acts as a chelating agent as well in the cleaning composition. BTA removal was characterized using contact angle measurements, X-ray photoelectron spectroscopy and electrochemical impedance spectroscopy (EIS) techniques. The corrosion protection ability of the cleaning solutions was quantified by potentiodynamic polarization studies. Both potassium hydroxide- and cesium hydroxide-based solutions exhibited high BTA and silica particle removal. When compared to a potassium hydroxide based cleaning solution, cesium hydroxide based cleaning solutions were found to be more effective in terms of low surface roughness and low etch rate. (C) 2014 Elsevier B.V. All rights reserved.
- Files in This Item
-
Go to Link
- Appears in
Collections - COLLEGE OF ENGINEERING SCIENCES > DEPARTMENT OF MATERIALS SCIENCE AND CHEMICAL ENGINEERING > 1. Journal Articles
![qrcode](https://api.qrserver.com/v1/create-qr-code/?size=55x55&data=https://scholarworks.bwise.kr/erica/handle/2021.sw.erica/22455)
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.