Joint properties and reliability of Cu/Sn-Ag pillar bumps via low-temperature thermo-compression bonding
- Authors
- Park, Jae-Yong; Lee, Ja Yeon; Park, Hwan-Pil; Kim, Sung-Chul; Lee, Tae-Young; Yoo, Sehoon; Kim, Young-Ho
- Issue Date
- Aug-2019
- Publisher
- ELSEVIER
- Keywords
- Low-temperature thermo-compression bonding; Nonconductive adhesive; Reliability; Cu pillar bump; Thermal cycle test; Temperature and humidity
- Citation
- MICROELECTRONIC ENGINEERING, v.216, pp.1 - 7
- Indexed
- SCIE
SCOPUS
- Journal Title
- MICROELECTRONIC ENGINEERING
- Volume
- 216
- Start Page
- 1
- End Page
- 7
- URI
- https://scholarworks.bwise.kr/hanyang/handle/2021.sw.hanyang/13304
- DOI
- 10.1016/j.mee.2019.04.030
- ISSN
- 0167-9317
- Abstract
- The joint properties and reliability of Cu/SnAg pillar joints via a low-temperature thermo-compression bonding (LT-TCB) process below the melting temperature of SnAg solder were investigated in this study. The bonding temperature was 150 °C. The pitches of the Cu/SnAg pillar bumps were 40 and 60 μm. The LT-TCB process was conducted using a non-conductive adhesive (NCA) and the post-curing of the NCA was conducted at 150 °C for 30 s. The SnAg solder was not melted but deformed to contact with the Cu pad following the LT-TCB. As the bonding time of the LT-TCB increased from 3 to 5 s, the gap between the SnAg and the Cu pad decreased and some areas showed an interfacial intermetallic compound (IMC) indicating that bonding had occurred. The electrical resistance of the LT-TCB samples increased after a temperature and humidity (TH) test and a thermal cycle (TC) test. The gap between the SnAg and the Cu pad decreased and interfacial IMCs formed in some regions following the reliability tests. The electrical resistance of the 3-s bonding sample was higher than that of the 5-s sample following the reliability tests. The bonding pressure also affected the joint properties. The electrical resistance after the TH and TC tests decreased with increasing bonding pressure. Without post-curing of the NCA, a crack occurred after the reliability test. The NCA did not fully cure during the LT-TCB; thus, the NCA did not play a role as a stress reliever.
- Files in This Item
-
Go to Link
- Appears in
Collections - 서울 공과대학 > 서울 신소재공학부 > 1. Journal Articles
![qrcode](https://api.qrserver.com/v1/create-qr-code/?size=55x55&data=https://scholarworks.bwise.kr/hanyang/handle/2021.sw.hanyang/13304)
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.