Joint configuration strategy for serial-chain safe manipulators
- Authors
- Hong, Seonghun; Lee, Woosub; Cho, Changhyun; Kang, Sungchul; Lee, Hyeong cheol
- Issue Date
- Nov-2014
- Publisher
- Institute of Electrical and Electronics Engineers Inc.
- Citation
- IEEE International Conference on Intelligent Robots and Systems, pp.2166 - 2171
- Indexed
- SCOPUS
- Journal Title
- IEEE International Conference on Intelligent Robots and Systems
- Start Page
- 2166
- End Page
- 2171
- URI
- https://scholarworks.bwise.kr/hanyang/handle/2021.sw.hanyang/143960
- DOI
- 10.1109/IROS.2014.6942854
- ISSN
- 2153-0858
- Abstract
- Multi-DoFs (Degrees of Freedom) manipulators with more than 6-DoF can perform complex and diverse tasks. To make these serial-chain manipulators safer, a variety of safety components were researched. If there is a crash at the end-effector of the serial-chain manipulators, components mounted on joints of the upper and lower arm can absorb the impact. Unfortunately, physical human-robot interaction does not occur only at the end-effector, a collision can happen anywhere from the base to the end-effector. If a collision occurs in the upper arm of relatively low DoFs, safety components attached to each joint may not work properly. Therefore, a study for joint configurations of serial manipulators is necessary with respect to the placement of safety components at the shoulder joint. Through various case studies, this paper verifies the appropriate joint configurations that place safety components at each revolute joint for physical human-robot safety.
- Files in This Item
-
Go to Link
- Appears in
Collections - 서울 공과대학 > 서울 전기공학전공 > 1. Journal Articles
Items in ScholarWorks are protected by copyright, with all rights reserved, unless otherwise indicated.